Post Holder with Point Black Coated 12.1 x 12.1 x 90 cm - Per Piece

Are you looking for bollard point with a Black coating? This post tip will complete any Fence with its chic look. This Black post holder is suitable for beams of 12 Ã- 12 cm beams or posts. The square holder and the upper part of the tip are powder-coated Black, giving this post extra protection against corrosion and rust. 

Black post tip 12 Ã- 12 cm placing

The total length of this post holder with tip is 90 cm. Only the tip is about 75 cm, when placing the pole tips, make sure the square part is just slightly above the ground. If you want to drive the pole into the ground it is wise to put a Piece of waste wood in the post, this will prevent you from damaging the Black coating. 

Pre-drill the post with a hardwood drill bit 6 mm in the holes of the post holder and install the post with our black m8 Ã- 50 coach screws. Order Washers Black M8 along because with these washers the coating of the pole tip will not be damaged during assembly. Let the pole float 3 to 4 mm in the pole holder. The holes at the bottom will then allow moisture running down from the post to drain easily. This makes your Wood less likely to rot from the underside.

Are you going to use these post holders for a structure that could be subject to a lot of wind? Pole tips are weaker in terms of strength than Wood posts in the ground and can bend in high winds. Make sure you create a triangular construction, by installing an extra batten at the Fence. 

Post Holder with Tip Black Coated 12.1 Ã- 12.1 Ã- 90 cm - Order

Order these black post holders with tip at the lowest price from Wovar. Companies in the handyman, landscaping or construction industry benefit from extra 

Is this post holder Black not quite what you are looking for? View our entire range of post anchors or pointed post anchors here. For making pergolas, we also offer useful pergola brackets.

Pergola brackets are also available.