Stainless Steel Floor Mounted Door Stop With Side Buffer - Per Piece

Are you looking for a solid doorstop? The floor-mounted door stopper with side buffer from Wovar stops your door without any problems. This doorstop is a popular choice, as its robust design allows it to be used both indoors and under a pergola, for example.

The Stainless Steel Door Stop with Side Buffer

The doorstop with rubber side buffer has a diameter of 85 mm and a height of 26 mm. The bumper is 23 mm high and 6 mm thick. In addition, this door stopper is finished with a stainless steel cap.

This door stop is supplied with mounting material. This consists of a screw 5 x 50 mm, a screw 5 x 70 mm, and corresponding plugs. You only need the plugs if you are going to mount the door stopper on a stone floor.

Tip: Is the door stopper not high enough? Then order our handy riser for the floor-mounted stainless steel door stop, with which you can increase the doorstop height by 12 mm. You will find these risers in the door stops category.

Mounting the Door Stop with Rubber Bumper on a Wooden Floor

When mounting the door stop with side buffer on a wooden floor, only use the supplied screws. You do not need the plugs in this case. 

If your floor is made of hardwood, it is a good idea to pre-drill the holes. Use our 3 mm hardwood drill bit for this . This way you can easily screw the screws into the floor and prevent the wood from splitting. 

Step 1: Determine the position of the door stopper
Step 2: Mark the mounting holes with a pencil
Step 3: Lightly drill the holes, approximately 20mm deep for the outer mounting hole and 40mm deep for the center mounting hole.
Step 4: Screw the doorstop into place with the 50mm screw in the outer mounting hole.
Step 5:  Place the cover on the door buffer.
Step 6:  Use the 70mm screw in the center of the doorstop to fully anchor the cap and doorstop.

Mounting the Door Stop with Side Buffer on a Stone Floor

When mounting the door stop with rubber bumper on a concrete or stone floor, use the supplied screws and nylon plugs. You also need a concrete drill. The nylon plugs are 10 mm wide, so in this case a concrete drill uses 10 x 120 mm. 

Step 1: Determine the position of the door stop
Step 2: Mark the mounting holes with a pencil
Step 3: Predrill the holes: 50 mm deep for the outer screw and 70 mm deep for the center screw.
Step 4: Press the plugs into the pre-drilled holes.
Step 5: Screw the door stopper into place with the 50mm screw in the outer mounting hole.
Step 6:  Place the cover on the door stop.
Step 7:  Use the 70mm screw in the center of the doorstop to fully anchor the cap and door stopper.

Order the Stainless Steel Floor Mounted Door Stop With Side Buffer

Order this robust door stop with side buffer from Wovar for a competitive price. And when you order 5 pieces or more, you immediately start enjoying our volume discounts.

Want even more benefits? Then become a business customer! Gardeners and construction and Handyman companies receive extra benefits with a business account, such as an extra business discount and a permanent contact person.

Not the doorstop you were looking for? Then you should also take a look at our full range of door stops. Or maybe a door closer or door holder offer a better solution for you.